ASI 10-0119-93 Recessing Kit for ASI Turbo-Dri Hand Dryers (for ADAAG compliance)
Reduces protrusion of TURBO-Dri™ to less than 4″, meeting both ADAAG and CalDAG barrier-free requirements. – 93 Satin Stainless Steel
Primary Material: | Stainless Steel |
Overall Dimensions: | 12" Wide x 17" Tall x 3-9/16" Deep |
Rough-In: | 10-3/4" Wide x 16-3/8" Tall x 3-3/4" Deep |
Net Weight: | 5.5 lbs. |
Shipping Dimensions: | 20" Length x 14" Width x 5" Height |
Shipping Weight: | 6.2 lbs. |
Compatibility: | TurboDri (10-0197) Series Hand Dryers |
Warranty: | Warranted to be free from initial defects in material and workmanship for a period of one (1) year from date of invoice. |
UPC / GTIN: | Not published |
Country of Manufacture: | Not published Buy American Act compliant |
Comments: | Mounting fasteners not included. |
Architectural Specifications:
Semi-Recessing mounting box shall reduce projection of TurboDri® dryer (0197) to less than 4" (102) from wall face for ADAAG and CalDAG Barrier Free Compliance. Cover shall be fabricated of 20 gauge cold rolled steel with white porcelain enamel to match dryer or type 304 stainless steel alloy 18-8 with satin finish or bright polished finish to match optional dryer finishes. All exposed satin or bright polished surfaces shall have finish protected by PVC film easily removed after installation. Wall box shall be fabricated of 20 gauge type 304 stainless steel alloy 18-8 with matt finish. Box shall have eight (8) 7/32" diameter (Ø5.6) mounting holes provided in sides on adjustable tabs (2 per vertical side) that eliminate requirement for shim fitting for installation purposes. Three (3) 7/8" diameter (Ø22) holes shall be provided on the bottom wall and one shall be provided on each bottom sidewall to facilitate power entry location. Mounting holes shall be provided in the box rear pan to match the mounting hole pattern of the dryer unit (mounting hardware is supplied with dryer units) and holes shall have captive ¼-20 threaded fasteners to receive dryer mounting hardware. Full-face cover shall be formed from one piece with no miters, welding or open seams on face and shall have 1/4" (6.4) square returns to wall. Cover shall be retained after closure with four (4) security pin-Torx ¼-20 flat head screws flush with panel face and shall have black rubber vibration isolation gasket. Structural assembly of all components shall be of welded construction. Cabinet shall have no exposed spot-welded seams.